How To Replace Motor/Gearbox on V10

Instructions  

Removal  

1. Unscrew and remove the front cover clip 
2. Unscrew the cable ties that hold the motor cables in place 
3. Using a 10mm socket, remove the bolts that hold the motor in place, removing the top two first so that you can separate the aerial from the motor/gearbox. (Only applies to Follow Units) 
4. Gently lift the Motor/Gearbox assembly out of the Chassis. Ensure the Motor Cable is removed from the Chassis at the same time.  
5. Remove Motor Cap and disconnect the Motor Cable.  

Replacing 

1. Connect Motor Cable to Motor. Note where the positive connects and the cable routing.  
2. Refit the Cap prior to installing the Motor/Gearbox assembly.  
3. Ensure the Cable does not pull out of the Motor Grommet. 
4. Using a 10mm socket, replace the bolts that hold the motor in place, replacing the top two first so that you can fit the aerial to the motor/gearbox. 
5. Screw back the cable ties that hold the electronic wires in place 
6. Screw the front cover clips back on 

Support Team Video 

https://youtu.be/BwqKV2yUkzY