Main Support on X Series and V10 needs replacing

Instructions  

Removal  

1. Using a T20 Torx Screwdriver, remove the screws that attach the handle to the main support 
2. Detach the handle from the main support 
3. Remove the bolts from the motor 
4. Remove the handle ratchets  
5. Remove the loose bolts 
6. Snip and remove cable ties 
7. Slide out the tie bar and remove the main support 

Replacing 

1. Place the main support in place  
2. Insert the tie bar 
3. Position the bolts into place (both sides) 
4. Tighten all bolts fully 
5. Secure the handle ratchets in place  
6. Reattach the tie wire and secure 
7. Reattach the handle  

Support Team Video 

https://youtu.be/tM-VM4Jfl3I