Instructions
Removal
-
Remove the front cover
-
Remove the screws and snip the cable ties to free the cables
-
Remove the clip holding the electronics box in place
-
Snip the cable ties to remove
-
Pop out the switch and remove from the cables
-
Pop out the LED and twist to remove from the housing
-
Unscrew and remove the front cover clip using a T20 Torx Screwdriver
-
Using a 10mm socket and spanner remove the nuts and bolts attaching the aerials to the cart
-
Snip the cable tie around the Motor
-
Slide back the cover around the motor and disconnect the cables on the top and bottom of the motor
-
Repeat the process for the other motor
-
Feed the cables under the rear cover and away from the motor
-
Repeat this process for the other aerial housing
-
You will now be able to remove the electronics from the cart
Replacing
-
Insert the new complete set of electronics into the X Follow
-
Make sure the longer cable and aerial housing is connected to the left-hand motor
-
Feed the aerial housing under the rear cover and attach it to the motor
-
Using the socket and spanner place and tighten the bolts holding the aerial on to the motor
-
Repeat the process for the other motor
-
Reattach the cables to the motor making sure that the BROWN cable is attached to the top and the BLUE to the bottom.
-
Tie the cable around the motor to hold the cables in place
-
Repeat the process for the other motor
-
Using the T20 Torx screwdriver, attach the front cover clip back into the rear cover
-
Place the cables into the grooves in the chassis and hold into place using the cable ties and screws
-
Feed the switch cables through the slot and attach the switch to both cables
-
Feed the LED cables through the slot place the LED sleeve over the LED until it clicks into place
-
Proceed to feed the supplies cable ties around the cables and tie bar and tighten
-
Repeat this process for both sides of the tie bar
-
Continue to place the cables on the left-hand side of the trolley in the designated grooves and secure with the cable ties and screws
-
Reattach the clip to secure the electronics box in place
Support Team Video
https://youtu.be/4GlPOr1tInc